Page 3 of 4
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Aug 02, 2015 12:02 pm
by Chris Hall
Will endeavor to get the first mailing for this project done this coming week.
Re: Hip Roof Model 2 - are you ready?
Posted: Tue Aug 04, 2015 6:11 am
by Yxoc
Great!
Half of the rafter stock is now dimensioned, another plank yet to be cut up but otherwise I'm ready to start...
Re: Hip Roof Model 2 - are you ready?
Posted: Sat Dec 24, 2016 11:27 am
by Chris Hall
Hey Derek,
I finally acquired Rhino 3D so the roof model I drew previously can now be accessed and edited. Wondering if you have any interest in resuming this project?
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Jan 22, 2017 6:20 am
by Yxoc
Chris,
So sorry I missed this, haven't checked in on the forum for a while.
Yes - I still have enormous interest in resuming this project
Warm regards
Derek
Oh and Merry Christmas and Happy New Year!
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Jan 22, 2017 9:33 am
by Chris Hall
Okay, good to know. Where are you at with stock prep for the model?
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Jan 22, 2017 8:13 pm
by Yxoc
Ready to go.
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Jan 22, 2017 8:52 pm
by Chris Hall
Well then, that means I've got to get up of my backside and produce something. I'll work on a mailing, the first subject of which will likely be the keta connection. A different joint than last time. Should have something done by the end of the coming week.
Re: Hip Roof Model 2 - are you ready?
Posted: Sun Jan 29, 2017 6:48 pm
by Chris Hall
Working on it presently. Another day or two...
Re: Hip Roof Model 2 - are you ready?
Posted: Wed Feb 01, 2017 7:19 am
by Yxoc
No probs.
Re: Hip Roof Model 2 - are you ready?
Posted: Wed Feb 01, 2017 9:00 am
by Chris Hall
Thanks. Yesterday I was careless about where I had left a cup of tea, and my 7-month old was curious to grab the cup, resulting in my keyboard getting soaked and killed. Got a new one today.
Also had a glitch with Rhino's export to Sketchup, which I did because I thought it might save time (as I'm a lot faster at SU at this point), however the file came through in a form that looked fine but was hard to modify. So, starting the sketching again I'm afraid....
Last night had 2 hours sleep as I'm excited about a potential job on the horizon. So, today is not looking promising for much more sketching.
We'll get there and I appreciate your patience.