Mortise chisels
- dmccurtis
- Sweeper of Floors, Maker of Tea
Post
Re: Mortise chisels
The delamination could be resultant of low-temperature forging, and relate to their cutting performance. It's sometimes a good 'flaw' to have. Perhaps Yamahiro is focusing his efforts on heat treatment, and not fit and finish, frustrating as that may be.
- Brian
- Deshi
Post
Re: Mortise chisels
I'll fine tune them on the belt sander and re-evaluate. I plan to put a slight hollow in the sides and a minor taper away from the edge.
I read a write up on tuning mortise chisels by Stanley Covington, so maybe it's not as unusual as I expect.
I also plan to email the seller to see if this is unusual.
I read a write up on tuning mortise chisels by Stanley Covington, so maybe it's not as unusual as I expect.
I also plan to email the seller to see if this is unusual.
- Brian
- Deshi
Post
Re: Mortise chisels
This is unusual according to Tomohito.
I have been debating the hollow grinding, it seems like high risk and low reward. So I'll probably just work them a bit more with diamond plates.
I have been debating the hollow grinding, it seems like high risk and low reward. So I'll probably just work them a bit more with diamond plates.
Who is online
Users browsing this forum: No registered users and 17 guests